Renogy 12V 200Ah Deep Cycle AGM

MPN RNG-BATT-AGM12-200

The Renogy 12V 200Ah Deep Cycle AGM is a battery pack with a nominal voltage of 12 V nominal, charging from 0 to 50°C, discharge from -20 to 60°C and 500 cycles.

Last updated: 27 October 2026

What we found

Matched to devices across several brands, by setting each maker's published figures against the other — neither names the pairing.
Matched to a charger, by setting each maker's published figures against the other — neither names the pairing.
Specifications are published for it, each with its source.
7 figures are unconfirmed.

Battery and charging

Float voltage it applies: 13.6V~13.8V
Voltage: 12 V nominal
Rated capacity: 200 Ah at the 20-hour rate, to 10.5 V
Capacity: 200Ah (20 Hour Rate to 10.5V)
Rated charge cycles: 500 cycles at 50% depth of discharge
Case material: ABS
Internal resistance: 3.5 mΩ
Maximum continuous discharge: 200 A continuous
Peak discharge: 2000 A for 5 seconds
Recommended charging: 30 A bulk, to 14.4 V
Series and parallel limit: Series allowed, and up to four in parallel
Highest charge current it will take: 60 A maximum
Maximum charge current, as the maker labels it: 60A
Charging voltage: 14.4 V to 14.8 V in cycle use
Float voltage: 13.6 V to 13.8 V
Voltage it cuts off at: Discharged to 11.1 V
How fast it loses charge sitting idle: Under 3% a month at 25°C

Battery care and safety

Temperatures it may be charged in: 0 to 50°C when charging
Temperatures it may be run in: -20 to 60°C when running
Temperatures it may be stored in: -20 to 60°C in storage

Size and fit

Overall dimensions: 20.6 × 9.4 × 8.8 inch
Torque for the battery terminal nuts: 88.5 inch·lb~106.2 inch·lb / 10 N·m~12 N·m
Stated weight: 127.9 lbs
Case material: ABS
Terminal thread: Two M8 bolts

Compatibility

Batteries the maker says it charges: Only a charger made for AGM or sealed lead-acid

Certification claims

Standards the maker claims: MSDS alone

Compatible chargers

These chargers are here because the published figures line up, not because anyone has said they go together — that is our reading of two documents that never mention each other, not a claim by either maker and not a test by us. Even where every figure agrees, these are not established:

Which charge profile the charger is actually set to — several publish four or more, and only one of them is this pack’s chemistry
What it holds the pack at once bulk charging ends, which is a different figure from the one it boosts to, and which some profiles do not apply at all
The charge current the pack will accept, against what the charger delivers into it
Whether the charger can restart a pack its own BMS has already disconnected
The wiring in between — where a converter feeds a distribution panel, the pack is one load on a circuit rather than a device on the end of a lead

Worth confirming with the charger's manufacturer or a dealer before buying.

DCC50S 12V 50A DC-DC On-Board Battery Charger with MPPTSKU DCC50S12V output50AFigures comparedView charger: DCC50S 12V 50A DC-DC On-Board Battery Charger with MPPT →
THE PACK'S OWN MAKER NAMES THE KIND OF CHARGER AND THIS IS ONE. Renogy say of this battery: “Only a charger made for AGM or sealed lead-acid”, and the DCC50S carries an AGM/SLD profile. The figures agree as well as the category does. On that profile the charger boosts to 14.6 V and floats at 13.8 V; the pack asks for 14.4 V to 14.8 V in cycle use and floats at 13.6 V to 13.8 V. Both charger figures sit inside both of the pack's windows. Set the charger to AGM/SLD: on the Gel profile it would boost to 14.2 V, below what this pack asks for.

Devices documented to run on this

The figures below line up. Neither manufacturer states that this pack runs this device — that is our reading of what each of them published separately, not a claim by either of them or a test by us. Even where every stated figure agrees, these can still decide it:

The device’s published draw is usually a peak, not the load it holds — the two numbers are not the same kind of quantity
A maker’s amp-hour minimum and their reserve-capacity minimum can give different answers about the same battery
Conditions attached to the chemistry, such as a speed limit for running on lithium
Whether the pack may be wired in series at all, where the device needs 24 or 36 volts
The charger, which both makers put conditions on and neither supplies
Case size, hold-down and terminal type — fitting the space is not being secured in it

Worth confirming with the device's manufacturer or a dealer before buying.

Two of these, identical to each other, wired in series for 24 V.

Three of these, identical to each other, wired in series for 36 V.

Only at 24 volts, and on published figures — neither maker has named the other and nobody has tested this pairing — check yours before buying.

Only at 36 volts, and on published figures — neither maker has named the other and nobody has tested this pairing — check yours before buying.

Minn Kota ask for “at least a 105 amp-hour rating”, in a paragraph about lead-acid: “The motor will operate with any lead acid, deep cycle marine 12-volt battery/batteries. For best results, use a deep cycle, marine battery with at least a 105 amp-hour rating.” This pack is AGM, so that is the figure that applies to it directly. This pack is rated 200 Ah and 200 A continuous. The pack's maker permits the series wiring this needs: "In Series, and In Parallel (up to 4) — Renogy state series support without naming a limit".

Source: johnsonoutdoors.widen.net/content/zp8zgjh29h/pdf/Terrova-BT-Installation-2327132rj.pdf

The motor's maker asks for 100 Ah minimum for a lead-acid or AGM battery, and 50 Ah to 100 Ah where the battery is lithium, and the battery must be able to supply 60 A of continuous current. This pack is rated 200 Ah and 200 A continuous. The pack's maker permits the series wiring this needs: "In Series, and In Parallel (up to 4) — Renogy state series support without naming a limit".

This pack is rated 200 Ah and 200 A continuous.

Compared on continuous figures only: nothing here is about surge.

Neither company names the other and nobody has tested the pairing.

Source: forestriverinc.com/files/component-manuals/Electrical/Progressive Dynamics - Inverter Model PD1600 Series Operation Guide.pdf

Minn Kota Terrova 55 lb (54" shaft, wireless remote)Figures comparedView device: Minn Kota Terrova 55 lb (54" shaft, wireless remote) →
One of these, on its own, at 12 V.
Only at 12 volts, and on published figures — neither maker has named the other and nobody has tested this pairing — check yours before buying.
Minn Kota ask for “at least a 105 amp-hour rating”, in a paragraph about lead-acid: “The motor will operate with any lead acid, deep cycle marine 12-volt battery/batteries. For best results, use a deep cycle, marine battery with at least a 105 amp-hour rating.” This pack is AGM, so that is the figure that applies to it directly.
Source: johnsonoutdoors.widen.net/content/zp8zgjh29h/pdf/Terrova-BT-Installation-2327132rj.pdf
Garmin Force Current (10–32 V, kayak)Figures comparedView device: Garmin Force Current (10–32 V, kayak) →
The motor's maker asks for 100 Ah minimum for a lead-acid or AGM battery, and 50 Ah to 100 Ah where the battery is lithium, and a 40 A continuous draw, which the circuit breaker is specified against. The pack's maker permits the series wiring this needs: "In Series, and In Parallel (up to 4) — Renogy state series support without naming a limit".
Minn Kota Terrova 80 lb (60" shaft, wireless remote)Figures comparedView device: Minn Kota Terrova 80 lb (60" shaft, wireless remote) →
Garmin Force Pro (20–45 V, 50" and 57" shafts, brushless)Figures comparedView device: Garmin Force Pro (20–45 V, 50" and 57" shafts, brushless) →
Minn Kota Terrova 112 lb (60" shaft, CHIRP sonar, wireless remote)Figures comparedView device: Minn Kota Terrova 112 lb (60" shaft, CHIRP sonar, wireless remote) →
Garmin Force (20–45 V, 50" and 57" shafts)Figures comparedView device: Garmin Force (20–45 V, 50" and 57" shafts) →
Garmin Force Kraken (20–45 V, 48" to 110" shafts)Figures comparedView device: Garmin Force Kraken (20–45 V, 48" to 110" shafts) →
Progressive Dynamics PD1620 Pure Sine Wave InverterFigures comparedView device: Progressive Dynamics PD1620 Pure Sine Wave Inverter →
Renogy rate this pack at 200 A continuous — their datasheet reads "200A" — and Progressive Dynamics publish a max current at max load of 200 A for the PD1620. The two figures are EQUAL, so a pack running this inverter at its full 2000 W would be at its maker's stated limit with nothing spare. That is a different statement from a comfortable fit, and neither company has made either.
Progressive Dynamics PD1618 Pure Sine Wave InverterFigures comparedView device: Progressive Dynamics PD1618 Pure Sine Wave Inverter →
Renogy rate this pack at 200 A continuous — their datasheet reads "200A" — against the PD1618's published max current at max load of 180 A, leaving 20 A in hand at the inverter's full 1800 W.
Progressive Dynamics PD1610 Pure Sine Wave InverterFigures comparedView device: Progressive Dynamics PD1610 Pure Sine Wave Inverter →
Renogy rate this pack at 200 A continuous — their datasheet reads "200A" — against the PD1610's published max current at max load of 100 A, leaving 100 A in hand at the inverter's full 1000 W.

Figures compared — they do not meet

Neither maker names the other. What these chargers publish and what this pack publishes do not meet, and each row below says how. That is our comparison of two documents and not a manufacturer’s refusal — check both against your own equipment before deciding anything.

WF-8900 Series Power ConverterFigures compared — they do not meetView charger: WF-8900 Series Power Converter →
Renogy state this pack's charge voltage as 14.4 V to 14.8 V in cycle use — their datasheet reads "Cycle Use Voltage 14.4V to 14.8V". WFCO's own manual gives this converter a target output of 13.6 VDC in normal use, rising to 14.4 VDC only in Bulk Mode, which it leaves "until the current draw drops to approximately five Amps, or until the timer reaches four hours (whichever happens first)". So the converter's normal output is below what this pack is specified to charge at, and 14.4 V to 14.8 V in cycle use is reached only during that Bulk phase. Neither company names the other, and neither has said anything about this pairing.

Do not charge with

The manufacturer states these chargers must not be used with this battery:

PD4500LI Series Power Control CenterStated incompatibleView charger: PD4500LI Series Power Control Center →
Progressive Dynamics state it outright about this converter: "The 4500LI series converter/chargers are designed to recharge lithium iron phosphate (LiFePO4) batteries only. DO NOT USE TO RECHARGE LEAD/ACID BATTERIES!" This pack is AGM, which is a lead-acid chemistry, so their sentence covers it. They say nothing about packs of other chemistries and nothing here extends it past what it covers.
Source: forestriverinc.com/files/component-manuals/Electrical/Progressive Dynamics - Power Converter Model PD4500 Series Operation Guide.pdf

Sources

Renogy 12V Deep Cycle AGM Battery (RNG-BATT-AGM12-100 / RNG-BATT-AGM12-200) — User ManualManufacturer document
Renogy
Source: cdn.shopify.com/s/files/1/0631/0137/0483/files/RNG-BATT-AGM12-100RNG-BATT-AGM12-200_12V_Deep_Cycle_AGM_Battery_EN__UM_A0_e2bde6ca-19b8-4adb-9104-008488db29ea.pdf
Retrieved September 11, 2026
Renogy DCC50S — User Manual, section 6.2 Battery Charging ParametersManufacturer document
Renogy
Source: renogy.com/cdn/shop/files/RBC30D1S-G3_G4_RBC50D1S-G6_DC-DC_with_MPPT_EN__UM_B5.pdf
Retrieved September 14, 2026
Progressive Dynamics PD4500 Series Operation GuideManufacturer document
Progressive Dynamics
Source: forestriverinc.com/files/component-manuals/Electrical/Progressive Dynamics - Power Converter Model PD4500 Series Operation Guide.pdf
Retrieved September 20, 2026
WFCO WF-8900 Series Power Converter Operator ManualManufacturer document
WFCO Technologies
Source: forestriverinc.com/files/component-manuals/Electrical/WFCO - Power Converter Model WF-8900 Series Operator Manual.pdf
Retrieved September 19, 2026
Progressive Dynamics PD1600 Series Operation GuideManufacturer document
Progressive Dynamics
Source: forestriverinc.com/files/component-manuals/Electrical/Progressive Dynamics - Inverter Model PD1600 Series Operation Guide.pdf
Retrieved September 20, 2026
Archived document
Source: renogy.com/cdn/shop/files/AGM200-Datasheet.pdf?v=1165370673493269635
Retrieved October 16, 2026